A HIGH VOLTAGE SOURCE HAS TWO SWITCHES IN SERIES FROM POSITIVE TO NEGATIVE TERMINALS ACTING AS COMPLIMENTARY LIKE WHEN ONE IS "ON" ,OTHER IS "OFF". THE INBETSEEN SWITCHES POINT IS A TOTEM POLE WHICH IS CONNECTED TO ONE END OF A RESISTIVE LOAD AND OTHER END OF THE THIS LOAD IS CONNECTED TO A 500 MILES LONG CONDUCTOR.THE CONDUCTOR HAS A 2.5 MILLISECOND TRAVELLING TIME ONE WAY. SO,WHEN THE TOTM POLE VOLTAGE GOES HIGH DUE TO THE CORRESPONDING SWITCH BEING ON ,THE CHARGE FLOWS THROUGH THE RESISTOVE LOAD TO THE FAR END OF THE CONDICTOR.THEN,THE FIRST SWITCH GOES OFF SND SECOND SWITCH COMES ON.SO!THE TOTEM POLE VOLTAGE GOES LOW AND THE CHARGE ON THE CONDUCTOR GOES TO THE NEGATIVE TERMINAL OF THE SOURCE FOR 2.5 MILLISECONDS. IN THIS PROCESS THE RESISTIVE LOAD DISSIPATES POWER WHEN THE SWITCHING RATE OF THE TOTEM POLE IS FIVE MILLISECONDS. HERE,THE RESISTIVE LOAD IS THE CITY LOAD AND THE LONG TRANSMISSION LINE IS A MODULE IN EACH CONSUMER'S PLACE AS AN OPEN ENDED DELAY LINE..NOT COAXIAL. MOST LIKELY NO TRANSMISSION TOWERS,TRANSFORMERS ARE REQUIRED BECAUSE THERE IS ARE NO SHOCK HAZARDS.
↧