Hello
I am trying to use Livelink to create a geometry in Matlab which I will then run a model on later. To build my geometric sequence I need a way of accessing properties such as the total volume of the currently built geometry. Is there a way to do this in Matlab. I need basically information similar to what the measure function in COMSOL would give me or that I would get using a volume integral probe over all the domains but in Matlab.
The way I found of doing this so far seems rather convoluted, I created a probe, ran a blank study from Matlab, exported the probe table and loaded it back into Matlab to give me the volume.
Best wishes,
David